[kcrutcher]

James

I did scan the receiver.

I Imported the scan into Corel, then used the line tool to draw around the edges and high points of the scan.

I then used the node edit tool to convert to curves where needed, pushed or pulled the lines to match the scan (similar to editing the flower demo).

Sorry If I took a long time to get back to you (I had computer problems for about a week)

I thought I had a Virus.

Turned out to be dust built up on CPU. (would overheat and shut down just when I was doing a virus check).

The processor works very hard during a virus check temp go's from 90 degrees F to 115 degrees and shut down.

Had me going around in circles for a while.

Let me know how you like X4 I am using X3.

Kenneth Crutcher