'nuther new guy

[tmik]

Better say something here..

I am a knife maker and knife supplies dealer. I've had a Lindsay airgraver set up since 2005 and have started and stopped learning engraving a dozen times. I have maybe a hundred+ hours total practice so not brand new but I understand how little that is in this craft.

I'm back at again and determined to see it through to the point where I can engrave my knives and feel good about it. I have a long way to go.

I don't care much for sharpening gravers.

I promise to use search before asking.

Thanks
T

[SEngraver]

Hi
Welcome to The Engraving Forum.
SE

[papart1]

welcome sir.........you'll have fun I am sure!!