|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,762. Welcome to our newest member, Katherine
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
12-31-2010, 05:23 PM
|
|||
|
|||
New Member
I am not an engraver. I am a client and admire quality work. Ken Hurst and Ralph Bone have done a little work for me. I do most of my own metalwork, but no stockwork. I know my limitations. I hope to enjoy your forum.
Butch 
|
|
#2
01-01-2011, 05:13 AM
|
||||
|
||||
Re: New Member
 Welcome Butch! Careful though, you may catch the engraving bug! 
__________________
Great Soapbox! Now if I just had something important to say! 
|
|
#3
01-02-2011, 11:59 AM
|
||||
|
||||
|
Re: New Member
Hi Butch,
Welcome here and maybe you could show your metal work? Happy new years, Daniel
|
|
#4
01-02-2011, 12:48 PM
|
|||
|
|||
|
Re: New Member
Daniel,
Pictured below is my latest. It is a 6.5X47Lapua on a Pierce receiver.  It has a Lilja barrel machined octagon. I made the scope bases and installed a 3 pos safety. It has a Shilen trigger. It is a single shot and the trigger guard was fabricated.  This second photo shows the trigger guard and grip cap before rust bluing. James Anderson did the stock, rust bluing, and the rear iron sight. Ken Hurst did the engraving except for the bolt knob.  The 3rd photo shows some of Ken's scratching and the bolt handle. It is a combination of 2 handles tig welded together. Jerome Glimm engraved the bolt knob.  The last photo is the octagon banded front sight. I was very proud at the way it turned out. Being an amateur it tested my limited abilities. Yes, it shoots very well. Thanks for allowing me to show this. Butch
|
|
| Bookmarks |
| Thread Tools | |
|
|
