|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, AnicaLin
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
11-18-2011, 08:06 AM
|
|||
|
|||
Circles
Hey im brand new...and small circles are giving me a fit! im using a 110square graver with a 45 face a 15 heel. any suggestions on graver? Or is it the guy running it?
 Any help would be greatly appreciated.
|
|
#2
11-18-2011, 09:38 AM
|
|||
|
|||
|
Re: Circles
Are you turning your work.... Your work tip should be practically fixed
|
|
#3
11-18-2011, 09:35 PM
|
||||
|
||||
|
Re: Circles
Work holding? Are you using a vise? If you center the work in the vice and start your cut, by turning the vise, not the graver, small circles turn out better! Still fighting with this myself, but when one turns out, I'm estatic!
|
|
| Bookmarks |
|
|
