Need help with my Palm Control

[Hamlertools]

I have a project that will be engraved in "soft brass" I made these 2 new cutters out of a softer material but am having difficulty installing them in the Palm Control.
Any suggestions would be appreciated.
Pauly

[jlseymour]

You need a larger PC...
Contact Steve Lindsay at
www.airgraver.com
You may consider a third Palm Control...
Have fun this weekend and you may want to take these with you and ask Steve at the show in KY...
Wish I could make it...
Seeya soon,,,
Jerry

[SVD]

Well first off it looks like you neglected to knock the back corners off - that's bad for the O-ring you know.

But based on the distance from the face to the back I think you need to add an extension anyway. Just take some 1/8" rod (I use brass) and clean up the back end of it after you attach it to the new 'points'. I grind a flat on one side to line up with the set screw, partly for indexing, partly so I don't have to adjust it differently for the round vs. square ends.

That ought to get you fixed right up. :thumbsup:

[David Jones]

That is quite puzzling to me!
i would think that if those gravers fit into the sharpening fixture that they should also fit in the pc
i am afraid that i have no help for you. LOL
those look like they will be a great tool so people can see the geometry of a sharpened graver
Dave

[Mcahron]

Nuthin abigo'l hammr wont fixx.:smilie5:

[Shy Shadow]

try some patrolum jelly that might help them slide in easier!

[metalman]

We know you are the king of small. Are those actual size gravers or are you playing with us and have build a minature palm control?