|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,774. Welcome to our newest member, Chuck Norris
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
04-27-2006, 04:44 PM
|
|||
|
|||
engraved bracelets with PalmControl
These bracelets I engraved with the Chasing PalmControl. They were engraved in the flat and then were formed into this synclastic form with a press.
Jack, Lee-Joyce Designs 
|
|
#2
04-27-2006, 05:19 PM
|
|||
|
|||
|
Re: engraved bracelets with PalmControl
Nice Jack,
Does the press have any effect on the engraving as far as smashing places or rounding corners etc.? Ray
|
|
#3
04-27-2006, 06:01 PM
|
|||
|
|||
|
Re: engraved bracelets with PalmControl
No Ray I have no ploblem with the engraving being damaged. I cover it with shelf paper
|
|
#4
04-27-2006, 11:18 PM
|
|||
|
|||
|
Re: engraved bracelets with PalmControl
We've actually engraved some tricky conchas - in the flat - then domed them without noticeable distortion. Almost all domed bracelets we work on are engraved flat and then domed.
Depends on how much you stretch the metal, in which direction(s), and most importantly - whether or not you are using a conforming type of die. If the work bottoms out, you'll definitely damage it. Using one of the thick urethanes to press into has never caused a problem... yet? Brian P. Marshall Stockton Jewelry Arts School Stockton, CA USA 209-477-0550 instructor@jewelryartschool.com
|
|
#5
04-28-2006, 08:46 AM
|
||||
|
||||
|
Re: engraved bracelets with PalmControl
Good work thanks for showing it, somthing on my list to try
|
|
#6
04-28-2006, 10:48 PM
|
|||
|
|||
Re: engraved bracelets with PalmControl
Yes, very good work, Jack. At first I was surprised to hear you bent the metal after engraving. Then I thought...why not.
wayne 
|
|
#7
04-29-2006, 08:10 AM
|
|||
|
|||
|
Re: engraved bracelets with PalmControl
Ya guys it is a lot easier to engrave in the flat and the press go's very fast. All the finishing is done before the press so they are ready to go after its done. A little adjustment is needed to the size but that is all. Jack
|
|
#8
05-01-2006, 08:49 PM
|
|||
|
|||
|
Re: engraved bracelets with PalmControl
Jack
What does this press look like? Is it like an arbor press? Mike
|
|
#9
05-02-2006, 07:42 AM
|
|||
|
|||
Re: engraved bracelets with PalmControl
Hi Mike: I use a Bonny Doon press with a asynclastic bracelet former. I am having a lot of fun with it. Take care Jack
|
|
| Bookmarks |
|
|
