|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, AnicaLin
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
12-21-2009, 04:10 PM
|
|||
|
|||
Hello and Merry Xmas
Hello from a retired medic in the UK, who is now an amateur engraver / stocker / gunsmith. As such I have little to show, so by way of introduction I am sending an Xmas card, of one of our dogs. This is engraved on copper, covered with printers ink which is then wiped off, leaving some ink in the engraving. and then pressed with a 6 ton bottle jack onto hand made paper.
As I do not know how to graft a photo into this page, I have put it into "Selbys album". While not comparable to some of the excellent work I have seen on this forum, I hope it brings some joy. 
|
|
#2
12-21-2009, 05:29 PM
|
||||
|
||||
|
Re: Hello and Merry Xmas
Thanks Selby,
Very nice engraving there! Wish I could do that  Best wishes too and welcome to this forum. Daniel
|
|
#3
12-22-2009, 07:31 AM
|
||||
|
||||
|
Re: Hello and Merry Xmas
Hello and Merry Xmas
Haha 
|
|
| Bookmarks |
|
|
