|
The Internet's Largest and Fastest Growing Engraving Community
Discuss hand engraving using basic to the most advanced methods and equipment
Forum Members: 14,761. Welcome to our newest member, AnicaLin
EngravingForum.com -
Domain since Feb 7, 2003
Graver Video Conferencing is empty Join now!
|
|||||||
| ENGRAVING TOOLS - Paypal accepted | Classes | Glossary | Feedback | Tips | Sharpening | Bulino | Videos | Forum Policies |
 |
|
|
Thread Tools |
|
#1
10-21-2010, 02:08 PM
|
||||
|
||||
Replace your soiled hose to keep idle low.
I just purchased 100 feet of replacement 1/8" o.d. clear PVC hosing for my Airgraver from Protubing @ http://protubing.com/ It was $12 delivered and I noticed my idle went back to the low level when the tool was new. With my Silentaire compressor the hoses soil up with oil in about 2 to 3 months and the idle begins to drop off. Even cleaning the tool won't completely help restore the low end idle.
|
|
#2
10-22-2010, 12:49 PM
|
||||
|
||||
|
Re: Replace your soiled hose to keep idle low.
Here in the Virgin Islands moisture is a big problem. I use 2 air/water seperators in line. Maybe that would help with your oil problem.
|
|
#3
10-22-2010, 06:08 PM
|
||||
|
||||
|
Re: Replace your soiled hose to keep idle low.
Thanks maplesm, I already have two filters in line. Changing the hose every couple months is pretty easy, especially now that I have it in bulk quantities. I drain the tank once a month of water. It sure does run nicer with the new tubing though. Amazing.
|
|
#4
10-26-2010, 01:04 PM
|
||||
|
||||
|
Re: Replace your soiled hose to keep idle low.
Good tip, gotta try this!
|
|
| Bookmarks |
|
|
